JBL Marine Bluetooth Receiver, 4x 6.5" 300W LED White Speakers, Amplifier w/Kit
New JBL PRV 175 AM/FM/USB/Bluetooth® Gauge Style Marine Boat Yacht Stereo Radio Player All-Environment Multimedia Stereo Receiver
JBL's PRV 175 marine digital media receiver will change the way you listen to music on your boat - without forcing you to cut or change your boat.
This digital media receiver packs a lot of features into a compact design that fits into a standard tachometer opening. You'll enjoy AM/FM radio, of course, plus built-in Bluetooth® that lets you stream music from your Android phone. You can also use the rear aux input for your music player, or plug a thumb drive into the rear USB port to enjoy your favorite music files.
The PRV 175 includes a set of rear-mounted preamp outputs, so you can expand your system with a marine amp in the future. The LED display tells you what you're listening to with just a glance, while the watertight, UV-stable face and controls will stand up to sun, salt and moisture when you're riding the waves.
General Features
- Marine Gauge Style Digital Media Receiver
- AM/FM tuner
- Bluetooth Audio Streaming
- Built-In Amplifier (45 peak x 4 channels)
- Waterproof Faceplate
- USB input and control-for USB drives only
- Auxiliary input
- 2 pair of RCA output
- Wired remote option
UPC Code 648701217503
These Infinity's Kappa Marine loudspeakers leverage Infinity’s world class audio engineering and music reproduction with purpose-built marine loudspeakers that will survive the rigors of the harsh marine environment. These 6-1/2" coaxial feature Plus One polypropylene woofer and midrange cones, Mylar tweeter domes, one piece cast polymer baskets, sealed magnets, and rubber woofer surrounds for high SPL performance. These speakers are UV resistant in a marine grade IPX3(IPX5 from front) weather resistant and include RGB perimeter illumination and go through 300 hours of salt spray testing.
General Features:
- Power Handling: 100 watts RMS, 300 watts peak power
- Sensitivity: 92dB at 2.83 volts
- Frequency Response: 40 - 25kHz
- Voice Coil Diameter: 1 in. (25.5mm)
- Impedance: 3 ohm impedance
- Plus One Woofer Cones
- Perimeter RGB Illumination
- One Piece Polymer Basket
- Mylar Tweeters
- Harman Standard Reliability Testing
DO NOT USE DRILLS ON THE SCREW SPEAKER TERMINALS EVER.
Loosen and Tighten BY HAND ONLY. Using a Drill snaps the solder connection on the back of the terminal and the X-over (coax) Circuit board.
UPC Code 050667373061
Infinity's marine 3004A amplifier will add plenty of muscle to your music without breaking a sweat, and it'll look good doing it. This 4-channel powerhouse delivers 75 watts RMS to each of the front and rear speakers in your boat. Into planning ahead? You could use this amp in 2-channel mode now to drive a couple subwoofers with 200 watts RMS each, then reassign it to your front and rear speakers when you get a bigger sub amp. Speaker-level inputs allow this amplifier to work in almost any system, even if you're keeping your marine's factory radio. You can use the separate high and low pass filters on the front and rear channels to maximize the performance of your speakers or subs.
General Features:
- 4 Channel Marine Amplifier
- 75 watts RMS x 4 at 4 ohms
- 100 watts RMS x 4 at 2 ohms
- 200 watts RMS x 2 at 4 ohms in bridged mode (4-ohm stable in bridged mode)
- Class H amp technology
- Variable high and low-pass filters on front and rear channels
- Preamp and speaker-level inputs
- Preamp outputs
- Fuse rating: 30A x 2
- 8-gauge power and ground leads recommended
- Wiring and hardware not included
UPC Code 050667380106
The Power Sport Motorcycle Universal Amplifier Wiring Kit includes the following 6 foot length of red and black T-Spec OFC power and ground wire with a T-Spec V8MANL fuse holder, 60 amp fuse protected by a black nylon braid, Pre-terminated ring terminals, (2) 4 foot pieces of 16 gauge OFC speaker wire protected by black nylon mesh and 4"x6" hook and loop mounting pad for micro-amplifiers.
Amplifier Wiring Kit:
- Designed tor motorcycles
- 6 feet of red and black T-Spec OFC power and ground wire with a T-Spec V8MANL fuse holder and 60 amp fuse protected by a black nylon braid
- Pre-terminated ring terminals make connections to the battery simple
- Two 4 foot pieces of 16 gauge OFC speaker wire protected by black nylon mesh makes upgrading the factory speaker wires or adding new speakers a smart choice
- Upgrading Harmon Kardon System – Two 47-ohm .5 watt resistors to keep the factory radio outputs active
- All the necessary installation hardware is included along wtth a 4 × 6 inch hook and loop mounting pad for micro-amplifiers to hold the amplifier securely in place
UPC Code 086429332267
