Bluetooth Digital Media Receiver, 4x 6.5" 180W Speakers W/Subwoofer, Amp W/Kit
JBL JAM 3000 is our entry level Marine audio source units designed for multi-element environments and amp; engineered to meet the demands of extreme environments while satisfying the performance requirements for Marine Audio consumers in this price range. The design is meant to integrate seamlessly into any boat design with an elegant and brand specific look and feel.
General Features:
- 2.8” Monochrome LCD Display
- 15 Watts x 4 Channel @ 4ohm
- Supports multiple audio sources
- Bluetooth, USB, AM/FM
- Audio output - RCA & Speaker level
- IP66 Marine Rated
- RMS Power Output 15Wx4
- 3Ch/2V Pre-out
- Eco-friendly Packaging
- Mounting options: Front & Rear
What's In The Box:
- 1 x radio
- 1 x accessory harness
- 1 x mounting bracket
- 1 x foam gasket for sealing at rear mounting surface
- 2 x foam strip gasket for sealing at front mounting surface
- 4 x mounting screws
- 2 x mounting bolts for top mount
- 4 x flanged nuts
- 2 x lock washers
- 1 x owner’s manual
- 1 x safety sheet
UPC Code 050036399432
These JBL Stage Marine Speakers are ready to take on your next outdoor adventure. These fully marinized speakers not only deliver JBL sound, but they bring the sound to life. Engineered to withstand sun, salt, sea spray and wash downs, they feature sealed motor structure, UV resistant one-piece cast-polymer baskets and rubber surrounds. The polypropylene cone and balanced dome tweeter provide great bass, smooth highs and lots of output to ensure every note can be heard loud and clear. Marine-grade materials & components have been used to suit the demands of a harsh outdoor environment. These speakers feature an IPx5 marine rating.
General Features:
- 6-1/2" (160mm) Marine Two-way Speaker with 1/2" (13mm) tweeter
- Power Handling: 60W rms, 180W peak
- Sensitivity (@ 2.83V): 90dB
- Frequency Response: 60Hz – 20kHz
- Nominal Impedance: 4 ohms
- IPx5 Rated
- Grille Mounted Tweeters
- Polymer Basket
- Individually Voiced
- Harman Standard Reliability Tested
- Bulk Packaging
UPC Code
This JBL Stage Marine Subwoofer is ready to take on your next outdoor adventure. This fully marinized spubwoofer not only delivers JBL sound, but it brings the sound to life. Engineered to withstand sun, salt, sea spray and wash downs, they feature sealed motor structure, UV resistant one-piece cast-polymer baskets and rubber surrounds. The polypropyelene cone provides great bass and lots of output to ensure low frequencies can be heard loud and clear.
General Features:
- IPx5 Rated
- Outdoor Performance
- Marine Design
- Balanced Dome Tweeters
- Rubber Surrounds
- Individually Voiced
- Harman Standard Reliability Tested
- Power Handling: 200Wrms, 600W peak
- Sensitivity (@ 2.83V): 88dB
- Frequency Response: 30Hz – 250Hz
- Nominal Impedance: 4 ohms
What's in the box?:
- 1 x Subwoofer with attached grille
- 1 x Stainless steel mounting hardware
- 1 x Drill bit for easy installation
- 1 x Foam gasket
- 1 x Subwoofer pigtail harness
- 2 x JBL sticker
- 1 x Quick Start Guide
UPC Code
The JBL Marine A5055 5-channel amplifier delivers a powerful 50-Watts RMS to each of the front and rear speakers in your boat, and a pounding 500-Watts RMS to the subwoofer channel — a much smarter ratio of subwoofer-to-full-range power than what is typical in 5-channel amps. You can also bridge the amp to 3-channel mode to deliver 140-Watts RMS to your front speakers while driving your sub with 500-Watts RMS. Speakerlevel inputs allow this amplifier to integrate into almost any system, even one using your Marine’s factory radio. Separate high-pass and low-pass crossovers on the front and rear channels allow you dial in the perfect roll off to best suit speaker placement and cabin acoustics. The subwoofer channel features a low-pass crossover, selectable bass boost, and phase switch to optimize subwoofer performance.
General Features:
- 5 channel Marine amplifier
- 50 watts RMS x 4 + 320 watts RMS x 1 at 4 ohms
- 75 watts RMS x 4 + 500 watts RMS x 1 at 2 ohms
- 100 watts RMS x 2 bridged at 4 ohms + 500 watts RMS x 1 at 2 ohms
- Variable high- and low-pass filters (32-320 Hz, 12 dB/octave) on front and rear channels
- Low-pass filter (32-320 Hz, 12 dB/octave) on subwoofer channel
- Bass boost on subwoofer channel (0-12dB at 45Hz)
- Phase switch on subwoofer channel (0, 180 degrees)
- Preamp and speaker-level inputs
- Fuse rating: 30A x 3
- 4-gauge power and ground leads recommended — wiring and hardware not included with amplifier
- WxHxD=360mm x 51.3mm x 180mm
- WxHxD=14-3/16” x 2-1/16” x7-1/8”
UPC Code 050036396950
The Power Sport Motorcycle Universal Amplifier Wiring Kit includes the following 6 foot length of red and black T-Spec OFC power and ground wire with a T-Spec V8MANL fuse holder, 60 amp fuse protected by a black nylon braid, Pre-terminated ring terminals, (2) 4 foot pieces of 16 gauge OFC speaker wire protected by black nylon mesh and 4"x6" hook and loop mounting pad for micro-amplifiers.
Amplifier Wiring Kit:
- Designed tor motorcycles
- 6 feet of red and black T-Spec OFC power and ground wire with a T-Spec V8MANL fuse holder and 60 amp fuse protected by a black nylon braid
- Pre-terminated ring terminals make connections to the battery simple
- Two 4 foot pieces of 16 gauge OFC speaker wire protected by black nylon mesh makes upgrading the factory speaker wires or adding new speakers a smart choice
- Upgrading Harmon Kardon System – Two 47-ohm .5 watt resistors to keep the factory radio outputs active
- All the necessary installation hardware is included along wtth a 4 × 6 inch hook and loop mounting pad for micro-amplifiers to hold the amplifier securely in place
UPC Code 086429332267
