Bluetooth Multi-Element Digital Media Marine Audio Receiver, 4x 6.5" 300W Coaxial White Boat RGB LED Speakers, 10" 900W RGB LED White Subwoofer, 5 Channel Amp W/Kit, Antenna, USB/AUX Adapter, Wire

---

JBL JAM 3000 is our entry level Marine audio source units designed for multi-element environments and amp; engineered to meet the demands of extreme environments while satisfying the performance requirements for Marine Audio consumers in this price range. The design is meant to integrate seamlessly into any boat design with an elegant and brand specific look and feel.

General Features:

• 2.8” Monochrome LCD Display
• 15 Watts x 4 Channel @ 4ohm
• Supports multiple audio sources
• Bluetooth, USB, AM/FM
• Audio output - RCA & Speaker level
• IP66 Marine Rated
• RMS Power Output 15Wx4
• 3Ch/2V Pre-out
• Eco-friendly Packaging
• Mounting options: Front & Rear

What's In The Box:

• 1 x radio
• 1 x accessory harness
• 1 x mounting bracket
• 1 x foam gasket for sealing at rear mounting surface
• 2 x foam strip gasket for sealing at front mounting surface
• 4 x mounting screws
• 2 x mounting bolts for top mount
• 4 x flanged nuts
• 2 x lock washers
• 1 x owner’s manual
• 1 x safety sheet

UPC Code 050036399432

---

These Infinity's Kappa Marine loudspeakers leverage Infinity’s world class audio engineering and music reproduction with purpose-built marine loudspeakers that will survive the rigors of the harsh marine environment. These 6-1/2" coaxial feature Plus One polypropylene woofer and midrange cones, Mylar tweeter domes, one piece cast polymer baskets, sealed magnets, and rubber woofer surrounds for high SPL performance. These speakers are UV resistant in a marine grade IPX3(IPX5 from front) weather resistant and include RGB perimeter illumination and go through 300 hours of salt spray testing.

General Features:

• Power Handling: 100 watts RMS, 300 watts peak power
• Sensitivity: 92dB at 2.83 volts
• Frequency Response: 40 - 25kHz
• Voice Coil Diameter: 1 in. (25.5mm)
• Impedance: 3 ohm impedance
• Plus One Woofer Cones
• Perimeter RGB Illumination
• One Piece Polymer Basket
• Mylar Tweeters
• Harman Standard Reliability Testing

DO NOT USE DRILLS ON THE SCREW SPEAKER TERMINALS EVER.

Loosen and Tighten BY HAND ONLY.  Using a Drill snaps the solder connection on the back of the terminal and the X-over (coax) Circuit board.

UPC Code 050667373061

---

Infinity KAPPA 1010M 10" Marine subwoofer feature Plus One polypropylene woofer and midrange cones, Mylar tweeter domes (Except Subwoofer), one piece cast polymer baskets, sealed magnets, and rubber woofer surrounds for high SPL performance. Wind, water or engine noise will not drown them out, UV resistant in a marine grade IPX3 (IPX5 from front) weather resistant and include RGB LED illumination.

General Features:

• 10" 3-Way Subwoofer
• Power Handling: 300 watts RMS
• Power Handling: 900 watts Max
• Sensitivity: 89dB
• Frequency Response: 20-22KHz
• Impedance 2 and 4-ohms, Switch Selectable Impedance (SSI)
• 7 color RGB LED Lights - expandable with remote
• Marine Grade IPX3 and IPX5 rated
• UV resistant
• Plus One polypropylene woofer

UPC Code 050667373108

---

Infinity's marine 7005A 5-channel amplifier provides a full system solutions without breaking a sweat, and it'll look good doing it. It delivers 50-Watts RMS to each of the front and rear speakers, and a ground pounding 500-Watts RMS to the subwoofer channel — a much better balance of "speaker-to-sub" power than most of conventional 5-channel amplifiers on the market. For higher output, you can bridge the amp to 3-channel mode and power your front speakers with 140-Watts per channel, while still delivering 500-Watts to the subwoofer channel. Speaker-level inputs allow the marine 7005A to work in almost any system, even if you're keeping your marine's factory radio. Separate high-pass and low-pass crossovers on the front and rear channels and dedicated low-pass crossover, bass boost, and phase switch for the subwoofer channel provides an incredible amount of control and tuning capability.

General Features:

• 5 Channel Marine Amplifier
• 50 watts RMS x 4 + 320 watts RMS x 1 at 4 ohms
• 75 watts RMS x 4 + 500 watts RMS x 1 at 2 ohms
• 100 watts RMS x 2 bridged at 4 ohms + 500 watts RMS x 1 at 2 ohms
• Class AB+D amp technology
• Bass boost and low pass filter on subwoofer channel
• RBC wired remote - volume adjustment
• Variable high and low-pass filters on front and rear channels
• Preamp and speaker-level inputs
• Preamp outputs
• Fuse rating: 30A x 2
• 4-gauge power and ground leads recommended
• Wiring and hardware not included

UPC Code

---

The Power Sport Motorcycle Universal Amplifier Wiring Kit includes the following 6 foot length of red and black T-Spec OFC power and ground wire with a T-Spec V8MANL fuse holder, 60 amp fuse protected by a black nylon braid, Pre-terminated ring terminals, (2) 4 foot pieces of 16 gauge OFC speaker wire protected by black nylon mesh and 4"x6" hook and loop mounting pad for micro-amplifiers.

Amplifier Wiring Kit:

• Designed tor motorcycles
• 6 feet of red and black T-Spec OFC power and ground wire with a T-Spec V8MANL fuse holder and 60 amp fuse protected by a black nylon braid
• Pre-terminated ring terminals make connections to the battery simple
• Two 4 foot pieces of 16 gauge OFC speaker wire protected by black nylon mesh makes upgrading the factory speaker wires or adding new speakers a smart choice
• Upgrading Harmon Kardon System – Two 47-ohm .5 watt resistors to keep the factory radio outputs active
• All the necessary installation hardware is included along wtth a 4 × 6 inch hook and loop mounting pad for micro-amplifiers to hold the amplifier securely in place

UPC Code 086429332267

---

This rugged Enrock EKMR1 marine soft wire universal antenna gives you performance, durability and plenty of placement options. The flexible wire makes it the perfect hideaway antenna, while the corrosion-resistant rubber exterior confirms that it will stand up to salt and spray. The 22inch long flexible wire will make mounting it a breeze.

General Features:

• 22" AM/FM Marine Antenna
• Improves Radio reception

UPC Code 799861388630

---

The Universal USB/3.5mm Auxiliary Interface Mount and Cable measures 10 feet in length and will convert your AUX inputs to USB.

AUX/USB Adaptor: 

• USB to RCA pass-through extension cable
• Cable Length: 3m (10ft)

UPC Code 799861390145

---

A ground-breaking virgin-PVC, Hyper-Flex insulation and multi-strand construction allows you to bend, twist, and contort the cable in any way imaginable for an ultimate installation experience while delivering maximum current flow; remains ultra-flexible under hot or cold temperature extremes; transfers the cleanest audio signal possible by using tightly twisted, silver-tinned OFC copper conductors; zip line to easily remove outer insulation.

Speaker Wire:

• 20 Feet
• 16 Gauge
• Silver-tinned OFC (oxygen-free copper)

UPC Code 632016086404