Infinity INF-BC4 Flush Mount Pre-Amp Bluetooth Controller, 4x 2x 6x9" 200 Watt Max 3-Way Boat Audio White Speakers, 45 Watts RMS @ 4 ohms Boat/Powersports Amplifier w/Install Wiring Kit

---

Enrock's EEA720.4 4-channel amplifier was designed compact yet rugged.  The outdoors can be a tough spot for audio gear so Enrock considered the salt, spray and sunlight when designing this Class D amplifier. With 45 watts RMS per channel this amplifier will drive your speakers no matter the application you are using it for. It’s compact enough for a bike and powerful enough for a car. You’ll have no trouble hearing your tunes over the wind and waves with this powerful amplifier.

Weather Resistant for Marine Application
Durable and Powerful for Automotive Use
Compact and rugged for Off-Road Installation

This compact amplifier will fit into a storage compartment on a boat, motorcycle, ATV, or car with optimal performance, despite its size. Should you decide to add a pair of subwoofers you can bridge this amp to a 2-channel mode and send 120 watts to each subwoofer, or switch to 3-channel mode to get a pair of speakers and a subwoofer. With high-pass and low-pass filters, plus bass boost, you can customize your sound output just the way you take your tunes.

EEA720.4 GENERAL FEATURES:

• 4-channel marine/powersports/ car amplifier
• 45 watts RMS x 4 at 4 ohms (60 watts RMS x 4 at 2 ohms)
• 120 watts x 2 bridged at 4 ohms
• Class D amp technology
• 720 Watts Peak Power
• variable high- and low-pass filters
• Sealed Chassis for use in harsh environments
• Ultra-efficient full range class D operation
• Built-in Crossover- maximum flexibility
• 2 or 4 channel input
• Signal to noise ratio 97db
• High pass filter 120Hz/80Hz
• Input range: 200mV-10V
• Frequency Response: 20Hz to 20KHz

UPC Code 728120454069

---

Dual DMS369 3-Way Marine Speakers are suited for installation into boats and other watercraft because they are specifically designed to last in harsh marine environments. The speakers have a one-piece basket design with a water shield and an integrated bridge mounted three-way make for voice coil protection. This ensures that sound quality will remain crisp and crystal regardless of the conditions.

• Features:
• Poly-coated cloth surround
• Magnetically shielded weather-resistant woofer
• UV impregnated ABS heat-resistant weatherproof grilles
• Stainless steel mounting hardware included
• Corrosion and rustproof basket design
• Woofer Size: 6" x 9"
• Type: 3-Way
• RMS Power: 50 Watts
• Peak Power: 200 Watts
• Dome Tweeter: 58mm
• Piezo Tweeter: 18mm
• Sensitivity: 89db
• Frequency Response: 42Hz - 17kHz
• Outside Diameter: 7.87" x 10.55"
• Cutout Diameter: 5.71" x 8.47"
• Top Mounting Depth: 3.47"
• Mounting Height: 1.34"

UPC Code 827204211113

---

The Infinity by Harman INF-BC4 Pre-Amp Bluetooth Controller allows consumers to pair his/her media device, and control basic functions through the Infinity controller. This stand-alone audio device features a rotary encoder and large buttons. Add an amplifier, speakers, pair, and stream from the Infinity by Harman BT controller. Easily control the volume of your Bluetooth audio with the rotary controller. IPX6 Waterproof and ready for outdoor use; no need to worry about the forecast. Requires 1 3/8" diameter hole to secure firmly in place.

General Features:

• Requires 12V power source
• Requires 1 3/8" diameter hole
• Internal Blutetooth chipset
• Dimensions (W x D)2" x 2"
• Wireless Bluetooth Streaming
• Rotary Encoder
• IPX6 Waterproof
• Flush Mount
• Large Buttons
• Durably Constructed

UPC Code 050667372866

---

The Power Sport Motorcycle Universal Amplifier Wiring Kit includes the following 6 foot length of red and black T-Spec OFC power and ground wire with a T-Spec V8MANL fuse holder, 60 amp fuse protected by a black nylon braid, Pre-terminated ring terminals, (2) 4 foot pieces of 16 gauge OFC speaker wire protected by black nylon mesh and 4"x6" hook and loop mounting pad for micro-amplifiers.

Amplifier Wiring Kit:

• Designed tor motorcycles
• 6 feet of red and black T-Spec OFC power and ground wire with a T-Spec V8MANL fuse holder and 60 amp fuse protected by a black nylon braid
• Pre-terminated ring terminals make connections to the battery simple
• Two 4 foot pieces of 16 gauge OFC speaker wire protected by black nylon mesh makes upgrading the factory speaker wires or adding new speakers a smart choice
• Upgrading Harmon Kardon System – Two 47-ohm .5 watt resistors to keep the factory radio outputs active
• All the necessary installation hardware is included along wtth a 4 × 6 inch hook and loop mounting pad for micro-amplifiers to hold the amplifier securely in place

UPC Code 086429332267