4x 6.5" RGB LED Speakers - Black, Bluetooth Adapter, Marine Amplifier, Amp Kit
The 6.5" marine speakers with Chrome Grilles are designed specifically for boats and the outdoors with a MAX power of 120 watts and a RMS power of 60 watts. Equipped with removable multi-color LED accent lighting that can be changed to fit your mood or craft. The bold, stylish design comes packaged with easy-to-match grilles for a customized look that includes a smart, integrated moisture-draining system.
General Features:
- 6.5" 2-Way Speakers
- Marine Grade
- RMS Power: 60 Watts
- Max Power: 120 Watts
- Impedance: 4 Ohm
- Sound Pressure Level: 88 dB
- Frequency Response: 64Hz to 20kHz
- Multi-Color LED Lighting
- Cone: PP Cone Rubber Edge
- Tweeter Material: Titanium
- Chrome Grilles - Included
UPC Code
Enrock 6.5-Inch (25cm) Grilles for EM265RGB Marine Speaker (Chrome, Pair)
Enrock 6.5" Grille for EM265RGB Marine Speaker (Chrome)
UPC Code
Enrock 6.5-Inch (25cm) Grilles for EM265RGB Marine Speaker (Charcoal, Pair)
Enrock 6.5-Inch (25cm) Grille for EM265RGB Marine Speaker (Charcoal)
UPC Code
The Infinity by Harman INF-BC4 Pre-Amp Bluetooth Controller allows consumers to pair his/her media device, and control basic functions through the Infinity controller. This stand-alone audio device features a rotary encoder and large buttons. Add an amplifier, speakers, pair, and stream from the Infinity by Harman BT controller. Easily control the volume of your Bluetooth audio with the rotary controller. IPX6 Waterproof and ready for outdoor use; no need to worry about the forecast. Requires 1 3/8" diameter hole to secure firmly in place.
General Features:
- Requires 12V power source
- Requires 1 3/8" diameter hole
- Internal Blutetooth chipset
- Dimensions (W x D)2" x 2"
- Wireless Bluetooth Streaming
- Rotary Encoder
- IPX6 Waterproof
- Flush Mount
- Large Buttons
- Durably Constructed
UPC Code 050667372866
Enrock's EEA720.4 4-channel amplifier was designed compact yet rugged. The outdoors can be a tough spot for audio gear so Enrock considered the salt, spray and sunlight when designing this Class D amplifier. With 45 watts RMS per channel this amplifier will drive your speakers no matter the application you are using it for. It’s compact enough for a bike and powerful enough for a car. You’ll have no trouble hearing your tunes over the wind and waves with this powerful amplifier.
Weather Resistant for Marine Application
Durable and Powerful for Automotive Use
Compact and rugged for Off-Road Installation
This compact amplifier will fit into a storage compartment on a boat, motorcycle, ATV, or car with optimal performance, despite its size. Should you decide to add a pair of subwoofers you can bridge this amp to a 2-channel mode and send 120 watts to each subwoofer, or switch to 3-channel mode to get a pair of speakers and a subwoofer. With high-pass and low-pass filters, plus bass boost, you can customize your sound output just the way you take your tunes.
EEA720.4 GENERAL FEATURES:
- 4-channel marine/powersports/ car amplifier
- 45 watts RMS x 4 at 4 ohms (60 watts RMS x 4 at 2 ohms)
- 120 watts x 2 bridged at 4 ohms
- Class D amp technology
- 720 Watts Peak Power
- variable high- and low-pass filters
- Sealed Chassis for use in harsh environments
- Ultra-efficient full range class D operation
- Built-in Crossover- maximum flexibility
- 2 or 4 channel input
- Signal to noise ratio 97db
- High pass filter 120Hz/80Hz
- Input range: 200mV-10V
- Frequency Response: 20Hz to 20KHz
UPC Code 728120454069
The Power Sport Motorcycle Universal Amplifier Wiring Kit includes the following 6 foot length of red and black T-Spec OFC power and ground wire with a T-Spec V8MANL fuse holder, 60 amp fuse protected by a black nylon braid, Pre-terminated ring terminals, (2) 4 foot pieces of 16 gauge OFC speaker wire protected by black nylon mesh and 4"x6" hook and loop mounting pad for micro-amplifiers.
Amplifier Wiring Kit:
- Designed tor motorcycles
- 6 feet of red and black T-Spec OFC power and ground wire with a T-Spec V8MANL fuse holder and 60 amp fuse protected by a black nylon braid
- Pre-terminated ring terminals make connections to the battery simple
- Two 4 foot pieces of 16 gauge OFC speaker wire protected by black nylon mesh makes upgrading the factory speaker wires or adding new speakers a smart choice
- Upgrading Harmon Kardon System – Two 47-ohm .5 watt resistors to keep the factory radio outputs active
- All the necessary installation hardware is included along wtth a 4 × 6 inch hook and loop mounting pad for micro-amplifiers to hold the amplifier securely in place
UPC Code 086429332267