JBL Marine Bluetooth Receiver, 4x 6.5" 225W LED Black Speakers, Amplifier w/Kit
New JBL PRV 175 AM/FM/USB/Bluetooth® Gauge Style Marine Boat Yacht Stereo Radio Player All-Environment Multimedia Stereo Receiver
JBL's PRV 175 marine digital media receiver will change the way you listen to music on your boat - without forcing you to cut or change your boat.
This digital media receiver packs a lot of features into a compact design that fits into a standard tachometer opening. You'll enjoy AM/FM radio, of course, plus built-in Bluetooth® that lets you stream music from your Android phone. You can also use the rear aux input for your music player, or plug a thumb drive into the rear USB port to enjoy your favorite music files.
The PRV 175 includes a set of rear-mounted preamp outputs, so you can expand your system with a marine amp in the future. The LED display tells you what you're listening to with just a glance, while the watertight, UV-stable face and controls will stand up to sun, salt and moisture when you're riding the waves.
General Features
- Marine Gauge Style Digital Media Receiver
- AM/FM tuner
- Bluetooth Audio Streaming
- Built-In Amplifier (45 peak x 4 channels)
- Waterproof Faceplate
- USB input and control-for USB drives only
- Auxiliary input
- 2 pair of RCA output
- Wired remote option
UPC Code 648701217503
These JBL Club Marine MS65LB 6.5" Speakers w/ the RGB Lighting Option are ready to take on your next outdoor adventure. These fully marinized speakers not only deliver JBL sound, but also feature RGB lighting to bring the sound to life. Engineered to withstand sun, salt, sea spray and wash downs, they feature sealed motor structure, UV resistant one-piece cast-polymer baskets, a sealed magnet and rubber surrounds. The polypropylene cone and balanced dome tweeter provide great bass, smooth highs and lots of output to ensure every note can be heard loud and clear.
General Features:
- 6.5" 2-Way Speakers
- Marine-Grade IPx5 Rated
- Power Handling: 75W RMS, 225W Peak
- Frequency Response: 50Hz-20kHz
- Impedance: 4 Ohms
- Harman Standard Reliability Testing
- Multi-Color RGB LED Lighting
- One-piece Polymer Basket
- Rubber Surrounds
- Foam Gasket
- Bridge mounted (grille mounted) tweeters
- Balanced Dome Tweeters
- Individually Voiced
- Stainless Steel Mounting Hardware
UPC Code 050036346252
The JBL Marine A754 4-channel amplifier delivers a powerful 75-Watts RMS to each of the front and rear speakers in your boat. You can also bridge the amp to 2-channel mode to drive a couple subs with 200 watts RMS or 3-channel mode to drive both a pair of full range speakers and a subwoofer. Speaker-level inputs allow this amplifier to integrate into almost any system, even one using your Marine’s factory radio. Separate high-pass and low-pass crossovers on the front and rear channels allow you dial in the perfect roll off to best suit speaker placement and cabin acoustics.
General Features:
- 4 channel Marine amplifier
- 75 watts RMS x 4 at 4 ohms (100 watts RMS x 4 at 2 ohms)
- 200 watts RMS x 2 at 4 ohms in bridged mode (4-ohm stable in bridged mode)
- Variable high- and low-pass filters (32-320 Hz, 12 dB/octave) on front and rear channels
- Preamp and speaker-level inputs
- Preamp outputs
- Fuse rating: 30A x 2
- 8-gauge power and ground leads recommended — wiring and hardware not included with amplifier
- WxHxD=320mm x 51.3mm x 180mm WxHxD=12-5/8” x 2-1/16” x 7-1/8”
UPC Code 050036396943
The Power Sport Motorcycle Universal Amplifier Wiring Kit includes the following 6 foot length of red and black T-Spec OFC power and ground wire with a T-Spec V8MANL fuse holder, 60 amp fuse protected by a black nylon braid, Pre-terminated ring terminals, (2) 4 foot pieces of 16 gauge OFC speaker wire protected by black nylon mesh and 4"x6" hook and loop mounting pad for micro-amplifiers.
Amplifier Wiring Kit:
- Designed tor motorcycles
- 6 feet of red and black T-Spec OFC power and ground wire with a T-Spec V8MANL fuse holder and 60 amp fuse protected by a black nylon braid
- Pre-terminated ring terminals make connections to the battery simple
- Two 4 foot pieces of 16 gauge OFC speaker wire protected by black nylon mesh makes upgrading the factory speaker wires or adding new speakers a smart choice
- Upgrading Harmon Kardon System – Two 47-ohm .5 watt resistors to keep the factory radio outputs active
- All the necessary installation hardware is included along wtth a 4 × 6 inch hook and loop mounting pad for micro-amplifiers to hold the amplifier securely in place
UPC Code 086429332267
