JBL Club A600 Subwoofer Amplifier Bundle with JBL Stage 1210D 12" Car Subwoofer
The JBL Club A600 amplifier features a low-profile chassis and a small overall footprint to fit in
more vehicles where available space is limited. Speaker-level and low-level inputs allow the Club A600 to integrate with both aftermarket and factory car stereo systems. Unlike many amplifiers available at similar prices, the JBL Club A600 features variable electronic crossovers and bass boost circuits allowing for precise system tuning and
performance.
The Club A600 has been engineered using Balanced Differential Inputs to ensure low noise
and distortion even at high output levels. This also makes it far less susceptible to line induced
radiated engine noise. When low-level inputs are used, this control adjusts the input sensitivity between 200mVrms and 2.0Vrms. When high-level inputs are used, this control adjusts the input sensitivity
between 2Vrms and 20Vrms.
On-board circuitry protects the Club A600 from shorts, high-temperature, overvoltage and undervoltage. An LED indicator is provided to let you know when one of these conditions exists. This switch changes the input phase to inverted or non-inverted. This is especially helpful as
part of system tuning based on the enclosure type and location in the vehicle.
The RBC wired remote is an easy installation and can be mounted for convenient volume
adjustment from driver’s seat.
The JBL Club A600 mono subwoofer amplifier delivers 600-Watts RMS using a Class D
amplifier design to ensure high output and minimum current draw.
This switch changes DC to REM to adapt with low-level signals or high-level signals, this is especially
helpful as part of remote turn-on lead of your installation more choice. A selectable “Turn-on mode”
can protect battery to avoid current drain, when you don’t expect to turn on your amplifier.
General Features:
- Mono subwoofer car amplifier
- 350 watts RMS x 1 at 4 ohms (600 watts RMS x 1 at 2 ohms)
- Class D amp technology
- Variable low-pass filter (32–320 Hz, 12 dB/octave)
- Variable bass boost (0-12dB at 45Hz)
- Phase switch (0, 180 degrees)
- Preamp and speaker-level inputs
- Fuse rating: 30A x 2
- 8-gauge power and ground leads
- recommended — wiring and hardware not included with amplifier
- Compact size
- High and low level input
- Variable crossover and bass boost
- Low noise and distortion
- Input Level Control
- Full on-board protection
- Phase Switch
- RBC wired remote
- W x H x D = 220mm x 51.3mm x 180mm
- W x H x D = 8-11/16" x 2-1/16" x 7-1/8"
UPC Code 050036369176
This JBL dual voice coil car subwoofer was engineered to deliver high-output, low-distortion bass with power handling capability of up to 1000 watts peak power. This subwoofer features lightweight yet stiff polypropylene woofer cone with hi-roll rubber surround to provide high-efficiency and super durability to best interface with a variety of amplifiers. The subwoofer has been individually tuned by some of the world's best transducer engineers to ensure they achieve the signature sound that is unmistakably JBL.
General Features:
- 12" subwoofer
- 4-ohm impedance
- Polypropylene cone
- Rubber surround
- Power handling up to 250 watts RMS
- Maximum power handling: 1000 watts
- Frequency response: 34-200 Hz
- Sensitivity (2.83V at 1 meter): 91 dB
- 2" Voice Coil
- Dual Voice Coil
- 5-15/16" Mounting Depth
- Grille not included
UPC Code 050036353878